Create these fun and super easy tile coasters with a few Sharpies and some rubbing alcohol! Ceramic tiles make an inexpensive substrate to make these wonderful abstract designs on – I find tiles from our local Re-Store in all different shapes and sizes! Perfect for inexpensive & unique gifts to give!
What you need:
- Sharpies or permanent markers
- 91% Isopropyl Alcohol
- Clear Coat spray – I used Rust-Oleum Gloss
- Ceramic Tile
- Adhesive Felt pads
- Small paint brush
Step one: Gather all your supplies and clean your ceramic tile surface with the rubbing alcohol, you can apply it to a cotton ball or paper towel!
Step two: Make sure your tile is dry from the rubbing alcohol, then start coloring your tile with your Sharpies or permanent markers! Keep in mind your colors are going to get moved around and colors will blend together – it’s best to just create abstract designs here, don’t try to create a picture, as it will get messed up in our next few steps!
Step three: Continue to color in your tile – you can leave some areas blank if desired, however, I find that the more color the better!
Step four: Dip your rush in the rubbing alcohol and gently “dab” the alcohol on the tile – a little bit goes a long way. You will immediately see the alcohol have an effect on the color.
Step five: Continue to add rubbing alcohol, I did mine in all dabs, creating a droplet effect. You could try splattering, brush strokes, or a combination to achieve different effects!
Step six: I continued to add dabs until all of my marker lines were gone. Be careful not to add too much rubbing alcohol as it moves and spreads your colors out, making the colors lighter and allowing more of the white to show through (this is why I find the more color the better in step three).
Step seven: Let you rubbing alcohol dry completely and then spray your tile with a clear coat – I used Rust-Oleum Gloss. Start with a very light layer of clear coat as sometimes it can effect your design. Let the light layer dry and then add a second coat to finish your tile!
Step eight: Let your tile dry completely – you can tell the clear coat effected my colors, making them a bit more muted!
Step nine: Once your tile is dry flip it over and add felt pads to the corners so your tile doesn’t scratch any surfaces! I used self adhesive felt pads but you could also hot glue cut felt pieces or cork as well!
Step ten: Enjoy your coaster! Or make and give as gifts!
1 thought on “Sharpie Tile Coasters!”